Thursday, November 3, 2016

4) Mac & Jack's Amber 12/4/2016

To combat my off-flavors i've been having, I made some adjustments to my process. Making a yeast starter was the first major change. I needed to almost double the cell count from the smack pack. I purchased a new clear fermentor to better gauge fermentation activity, and I will be keggin this time to mitigate bottle-conditioning hassles.

Ken Nabors, the operations manager and head brewer for Mac and Jack’s says this beer is a “big, full-bodied amber beer” that does not readily fit into any traditional beer style. Ken was a bit shy when it came to giving out details about the ingredients and other brewing specifics, but he did say Mac and Jack’s has a citrus hop flavor up front, followed by a floral hoppy finish, which they achieve by dry-hopping in each individual keg. Ken also suggested using a yeast that produces a malty flavor in the beer. Clean yeasts are another feature of West Coast pale ales. Mac and Jack’s ages the beer for a few weeks before sending kegs out to the local pubs. They keep a close watch on the kegs they have out, making sure that pub patrons are always served this beer in its prime.



(5 gallons, extract with grains)

RECIPE: OG: 1.060 FG: 1.018 IBUs: 38 ABV: 5.5%

ACTUAL: OG: 1.051 FG: 1.014 IBUs: 38 ABV: 4.7%


Ingredients


7 lbs. Light malt extract syrup
.5lbs. Dry Light malt extract
1.0 lb. Munich malt
0.5 lb. crystal malt (80° L)
0.5 lb. Carapils (dextrin) malt
9.3 AAU Centennial hops (bittering) (1 oz. of 11.2% alpha acid)
6.2 AAU Cascade hops (aroma) (1 oz. of 8.1% alpha acid)
4.2 AAU Cascade hops (dry hop) (0.5 oz. of 8.1% alpha acid)


Wyeast 1098 (British Ale) yeast

Step by Step


Steep the crushed malts in three gallons of water at 150º F for 30 minutes. Remove the grains from the wort. Add the malt syrup and malt powder and bring to a boil. Add the Centennial (bittering) hops and Irish moss and boil for 60 minutes. Add the aroma hops (Cascade) for the last two minutes of the boil. When done boiling, strain out hops, add the wort to two gallons of cool water in a sanitary fermenter, and top off with cool water to 5.5 gallons. Cool the wort to 80º F, aerate the beer and pitch your yeast. Allow the beer to cool over the next few hours to 68–70º F and ferment for 10–14 days. Add the 0.5 oz. of Cascade pellets to keg suspended with dental floss.








1250ml of wort for 1.060 OG
First starter attempt is doing its thing. I used the Brewers Friend yeast starter calculator. The yeast is 14 days old, viability was 87 billion cells so I made a 1.25liter starter 2   days in advance for 200 billion cells 0.71M cells / mL / °P











Started siphoning wort from kettle to the fermentor to avoid oxygen exposure




Activity seen after 4 hrs, the pitch temp was 65 but I raised the temp to 70 to kick off fermentation, the temp was lowered back to ambient which is around 64. The SG came out low, mainly because I added too much water to the fermentor





About 16 hours into primary fermentation





3 days in, the krausen dropped, ramped up to 72 degrees and threw in some Cascades (about .75oz)






The first FG reading as 1.014 after 72 hours






No comments:

Post a Comment